Ok so im certain that this is not due to my machine because i had these problems on both my laptop ad desktop PC. So 2 weeks ago i started an update on the laptop and it crashed near the end. After it it wouldnt boot in normal mode so i went into advanced mod it told me that if it had crashed during the update to input some command in the terminal, I did and it finished the update, i had no issue after that.
However today i start an update on my pc and around the middle it crashed. It boots in normal mode but when i try to update the update window starts, pulls some data and closes. Same happens on advanced mode.
I span a new whonix pair and it updated without a problem.
Im more worried about my kicksecure vm’s that i have stuff on i dont want them to crash and become unusable, also how important are the las2 2 updates are there any critical fixex or quality of life improvements, id like to delay updating my other vms untill all problems are resolved.
Update:
So i had 2 other unupdated instances of whonix. I went in the advanced mode and used the 10.95 version to initiate the update. In the 1st instance it went trough smoothly, in the 2nd it crashed but i was able to finish the update with the sudo dpkg --configure -a command
Can you describe what you mean by “crashed”? Did the updater process quit without warning, printing a message along the lines of “Segmentation fault (core dumped)”? Did the terminal window the updater runs in close without warning? Did the VM spontaneously reboot? Were any messages shown indicating what went wrong? Without this info, it’s hard to know what’s wrong.
1 Like
By crashed in the firce instance on my laptop the VM’s 2 whon and 1 kick just rebooted when i was like 90+% into the update however after going into the advance mode and selecting the 10.95 version i was able to finish the updates with the sudo dpkg --configure -a command.
On my PC the latest batch of updates, not only made the vms restart toward id say middle of the update not the end, but when i go in advanced any version and try to update it initiates the install window it Hits few of the addresses and it just closes. In the sys-split mode it doesnt even want to start the installation window.
Update:
So i had 2 other unupdated instances of whonix. I went in the advanced mode and used the 10.95 version to initiate the update. In the 1st instance it went trough smoothly, in the 2nd it crashed but i was able to finish the update with the sudo dpkg --configure -a command
Sounds like panic-on-oops is causing the OS to crash. You can disable it by following the instructions here:
Note that doing this reduces system security, so you should consider turning it back on in the future.
1 Like